How We Repair Your Grease Trap
Garbage disposals, trash compactors and grease traps handle kitchen waste with motors, rams, switches and seals.
Common Grease Trap Problems We Fix
Compactor ram does not move
A worn drive chain or nut, a failed motor or a safety switch.
Grease trap backing up or smelling
It needs pumping or the baffles are damaged.
Disposal hums but does not spin
A jammed flywheel or a failed motor.
Disposal will not turn on
A tripped reset button, a switch or a wiring problem.
Leaking under the sink
A loose mounting ring, worn gasket or a cracked housing.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Press the red reset button under the disposal
- With the power off, turn the flywheel with a disposal wrench
- Check that the compactor drawer is fully closed
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your grease trap is doing and when it started. We schedule the first available visit, with priority for equipment that is stopping your business.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Disposal motor unit
- Mounting gaskets
- Reset switch
- Compactor drive nut and chain
- Compactor motor
- Safety switches
Cost and Lifespan
Most grease trap repairs cost $100–$350 including parts and labor, and these appliances typically last 8–15 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Keep grease, bones and fibrous food out
- Pump grease traps on schedule
- Run cold water while the disposal runs
Grease Trap Repair in Sebring, FL
We repair grease traps in Sebring (ZIP codes 33870, 33871, 33872, 33875 and 33876) and in nearby communities including Avon Park, Lake Placid and Frostproof. Long, humid summers in Florida push refrigerators, ice makers and AC units in Sebring hard for most of the year.
Frequently Asked Questions
How much does Grease Trap Repair cost in Sebring, FL?
Most grease trap repairs fall between $100–$350 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my grease trap today?
Same-day visits depend on technician availability in Sebring. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Which brands of grease trap do you repair?
We repair all major brands. See the brand list on this page, or call with your model number and we will confirm.
Should I repair or replace my grease trap?
A grease trap typically lasts about 8 to 15 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.